NovaScale R620 User Guide
7-17
(For details, see chapter 4
“
Monitoring Configuration
”
.)
* After completion of CHKDSK, restart the machine and change the above setting back to [Enable]
and continue the operation.
CHKDSK is executed in the following conditions:
(1) CHKDSK is scheduled to be executed at next system startup
(2) Corruption of file system is detected since the previous startup until shutdown
(3) Inconsistency (corruption) of file system is detected while mouting at system startup
Is the value of [Boot Monitoring] in the BIOS setting appropriate?
Change the value of [Boot Monitoring] to suit your environment.
(For details, see chapter 4
“
Monitoring Configuration
”
.)
Disk access LEDs on the disks are off:
The LEDs may seem to be off when an excessive amount of access causes the frequent blinking. Check
if the LEDs are blinking green when the access is reduced.
CPU/IO module is disconnected:
When an error occurred in a CPU/IO module, the following message will be recorded to the system
event log and the CPU/IO module may become disconnected. In this case, contact your sales agent
because device replacement will be required.
Source:
HasCtrl
Type:
Error
Event ID:
3400
Description: FT nonfatal error occurred on the Module [Module Number]. [Module number]
“
#0
”
or
“
#1
”
.
Source:
HasCtrl
Type:
Warning
Event ID:
4323
Description: The system abnormality of the Module [Module Number] was detected.
[Module Number]
“
#0
”
or
“
#1
”
.
CPU module is disconnected:
When an error occurred in the CPU module, the following message will be recorded to the system event
log and the CPU module may be disconnected. CPU module will be set to duplex mode again, so there
will be no effect on the system by this warning. If reintegration fails, see
“
CPU module is not
integrated
”
of this chapter.
Source:
HasCtrl
Type:
Warning
Event ID: 1202
Description: The driver failed the fast re-sync function of the CPU module. [Module[Module
Number]]
[Module Number]
“
#0
”
or
“
#1
”
Source:
HasCtrl
Type:
Warning
Event ID: 3500
Description: The error occurred on the CPU module of Module [Module Number]
[Module Number]
“
#0
”
or
“
#1
”
Source:
HasCtrl
Type:
Warning
Summary of Contents for Bull NovaScale R620 Series
