Mitsubishi Electric MR-J2S-10CP, Instruction Manual

Page: 93 / 357

4 - 2
4. OPERATION
4.1.2 Startup
WARNING Do not operate the switches with wet hands. You may get an electric shock.
CAUTION
Before starting operation, check the parameters. Some machines may perform
unexpected operation.
Take safety measures, e.g. provide covers, to prevent accidental contact of hands
and parts (cables, etc.) with the servo amplifier heat sink, regenerative resistor,
servo motor, etc.since they may be hot while power is on or for some time after
power-off. Their temperatures may be high and you may get burnt or a parts may
damaged.
During operation, never touch the rotating parts of the servo motor. Doing so can
cause injury.
Connect the servo motor with a machine after confirming that the servo motor operates properly alone.
For startup reference, a single machine structure will be described. Refer to this section and start up the
machine safely.
(1) Machine conditions
Point table No. 1
Servo motor
HC-MFS131072pulse/rev
Servo motor
speed
Ballscrew
P
B
10mm(0.39inch)
Reduction ratio
1/n 1/2
Servo amplifier
Regenerative
option
MR-RB032
Ta
Tb
0r/min
V
Position data (P) 200mm(787.40inch)
Speed (V) 2500r/min
Acceleration time constant (Ta) 200ms
Deceleration time constant (Tb) 300ms
P
P
B
1) Absolute position detection system used
2) Command resolution: 10 m
3) Command system: Absolute value command system
4) Electronic gear calculation
CMX(pulse)
CDV( m)
131072 131072
10
131072
5000
32768
1250
1
n P
B
1000 1000
1
2
........................................................(4.1)
CMX 32768
CDV 1250
5) For the device command method, external input signals are used by the point table selection,
forward rotation start (ST1), servo-on (SON) and other commands.
6) Point table No.1 is used to execute automatic operation once.