Mitsubishi Electric MR-J2S-10CP, Instruction Manual

Page: 195 / 357

7 - 14
7. DISPLAY AND OPERATION
(2) Setting of 6 or more-digit value
The following example gives the after-power-on operation procedure to change the target value of
point table No.1 to "123456".
Press SET once.
Setting of lower 3 digits
The screen flickers.
Enter the setting.
Setting of upper 3 digits
Press SET once.
Press MODE once.
Press SET once.
Press UP or DOWN to
change the setting.
Press SET once.
Press MODE once.
Press MODE three times. Press UP or DOWN to choose point table No. 1.
Note. The example assumes that the status display screen that appears at power-on has been
set to the servo motor speed in parameter No. 18.
(Note)
Press "
UP
" or "
DOWN
" after completion of the setting to return to the setting item screen. Further,
press "
UP
" and "
DOWN
" together to return to the point table No. display screen.