Mitel 6873i SIP Phone Release 4.2.0 SP2 User Guide
8
INSTALLATION AND SETUP
If your System Administrator has not already setup your 6873i phone, please refer to the
Mitel
6873i Installation Guide
for basic installation and physical setup information. For more
advanced administration and configuration information, System Administrators should refer to
the
Mitel SIP IP Phones Administrator Guide
.
CLEANING THE 6873I TOUCHSCREEN
Repeated use of the 6873i touchscreen may lead to a dirty screen. To clean the phone’s screen,
Mitel recommends the use of a super fine cotton cloth, cotton swab, or microfiber lens cloth
made of microfiber suede (preferably one without sewn hems or similar characteristics that
would scratch the surface of the screen). You can use the cloth dry for dusting, polishing and
light cleaning, or dampen it (with water only) to deep clean the surface. If using a damp cloth,
make sure to use just a little water on the cloth. Too much moisture can cause damage to your
phone that could be permanent. If the cloth is dripping or the surface shows water spots after
wiping, then you are using too much water on the cloth.
Some rules to follow when cleaning your screen include:
•
Do not use any sharp objects including your fingernail.
•
Do not rub, touch or tap the surface of the screen with sharp or abrasive items such as a
ball-point pen or a screw driver.
•
Do not use any type of cleansers including abrasive cleansers.
•
Do not use any type of glass cleaner or any cleaner that contains alcohol or ammonia.
•
Do not spray any type of cleaner directly on the phone’s screen.
•
Do not allow any liquid to run down the surface of the touchscreen and under the bezel.
•
If using a damp cloth, disconnect power to the phone before wiping the screen.
To clean your 6873i touchscreen:
1.
Disconnect power to your phone.
2.
Retrieve a soft cloth, such as a microfiber cloth.
3.
If necessary, dampen the cloth. For regular cleanings, a dry cloth is usually sufficient. For
stubborn build-up or for periodic deep cleanings, wet the cloth under a faucet and then
wring out until it is just damp.
4.
Wipe the screen gently with the cloth making sure to not get any moisture in the sides of
the screen. You can also wipe down the entire phone to remove dirt and grime.
5.
Allow your phone to completely dry after you are done cleaning. This should only take a
few minutes.
6.
Reconnect power to your phone.
CAUTION: Use of any type of cleaners, alcohol, ammonia, and/or hard or sharp
objects can harm the touchscreen surface and potentially cause transparent
conductive film cracks in the screen.
Note:
Keeping your touchscreen clean and free of dirt and fingerprints on a regular basis
extends the life of your phone’s touchscreen.
