3-7
© Copyright 2006 Microwave Data Systems Inc. All Rights Reserved
User Interface Manual
MDS FIVE Series
05-4574A01, Rev. C
3.1.3.2.2 Trap Version
A trap is an SNMP message issued by an SNMP agent that reports an event.
The Trap Version parameter configures the SNMP trap version. The SNMP agent
uses the specified version to send the traps to configured trap managers.
3.1.3.2.3 Auth Trap Enable
If enabled, SNMP agent generates Authentication failure trap on authentication
failure in any request.
3.1.3.2.4 Read Community
A community string is an SNMP security password. The Read Community string is
used in read operation of SNMP v1 or v2, and allows the SNMP manager to issue
Get and GetNext messages.
3.1.3.2.5 Write Community
The Write Community string is used in write operation of SNMP v1 or v2, and
allows the SNMP Manager to issue Set messages.
3.1.3.2.6 Trap community
The Trap Community string allows the SNMP agent to issue Trap messages.
3.1.3.2.7 SNMP Auth Password
The SNMP Auth Password is used in only SNMP v3 mode of operation and is the
authorization password for the “admin” user.
3.1.3.2.8 SNMP Priv Password
The SNMP Priv Password is used in only SNMP v3 mode of operation and is the
privacy password for the “admin” user.
3.1.3.2.9 Trap Manager
Trap Manager configures the trap manager’s IP addresses. A maximum of four
Trap managers can be configured. The SNMP agent sends the traps to all the
configured trap managers.
3.2 Navigation Tree
The Navigation tree shown describes the location of each user interface screen.
Nested screens are indented under the screen from which they can be accessed.
j
Home
