HANDHELD TRANSMITTER
NOTE:
This unit is equipped with an automatically learned
type remote control. There are no frequency switches on the
receiver and transmitter; the receiver unit will automatically
scan the frequency from the handheld remote if any changes
are made. This unit has 65,000 different code combinations.
Remote pairing process:
Install batteries included with the transmitter. (Fig. 1)
NOTE:
To prevent damage to the transmitter, remove these
batteries if not used for long periods of time (months).
With the fan’s power off, restore power to the fan. Press and
hold “
” button for about 5 seconds and release. If optional
light kit is installed, the light kit will flash twice and the signal
light on the handheld remote will come on when the button is
pressed. The fan has completed the pairing process with the
handheld remote and is ready for use.
Model:
3-8-1000-0
Fig. 1
Fig. 2
A.
H, M
and
L
buttons: (Fig. 2)
These three buttons are used to set the fan speed as follows:
H= high speed
M= medium speed
L= low speed
B.
button:
This button turns the fan off.
C. The " " button:
The " " button turns the light ON or OFF and also
controls the brightness setting. Press and hold the button to
dim and brighten the light. Press and hold the button and
release the button at desired brightness. The light key has an
auto-resume, it will stay at the same brightness as the last time
it was turned off.
D. The " " button is used to set the fan forward or
reverse, press the button forward (for warm weather) or
reverse (for cool weather).
NOTE:
To operate the reverse function on this fan, press the
reverse button while the fan is running.
OPERATING INSTRUCTIONS
