User Interface Manual
© Copyright 2006 Microwave Data Systems Inc. All Rights Reserved
3-22
MDS FIVE Series
05-4574A01, Rev. C
3.3.8.1 Description
This screen is used to configure STP NMS status (enable/disable) and Bridge
priority. (see Figure 3-12).
3.3.8.2 WEB Configuration
1. Navigate to and click on the Administration
Æ
Network Configuration
Æ
STP
NMS.
2. All STP NMS parameters (STP Status and Bridge Priority) are displayed
with current/present values.
3. To revert to previous value, press Reset button.
4. To change the parameters, enter new values and press the “update”
button.
3.3.8.3 CLI Configuration
1. Navigate to Administration
Æ
Network Configuration
Æ
STP
Configuration
Æ
NMS Switch Configuration
2. All STP NMS parameters (STP Status and Bridge Priority) are displayed
with current/present values.
3. To edit an individual parameter, enter its hotkey, modify its value by
scrolling through the options using the Space Bar key, and press “Enter”.
4. To revert to the previous value, press the “Esc” key while editing the value.
5. To update the edited parameter, press the hotkey for “Update”.
6. The page is refreshed and displayed with the updated or current/present
values.
3.3.8.4 SNMP Configuration
1. Select a parameter from the MIB section
ccmSDIDUSysCfgNetworkSTPNMS
2. Use the SNMP GET command to get the value of the required parameter
3. Use the SNMP SET command to set the value of the required parameter
4. The SNMP agent will return the actual value upon successful set or get
operation. Upon failure, the SNMP agent will return an error if the value set
is out of range, or the agent is not able to get or set the value, or the user
does not have access rights to the selected parameter.
