3-59
© Copyright 2006 Microwave Data Systems Inc. All Rights Reserved
User Interface Manual
MDS FIVE Series
05-4574A01, Rev. C
3. To select a Preferred ODU (only in protected 1+1 mode), click on the radio
button (East/West) and press the “update” button.
3.3.31.3 SNMP Configuration
1. Select a parameter from the MIB section
ccmSDIDULinkCfgRadioLinkProtection.
2. Use the SNMP GET command to set the value of the required parameter.
3. The SNMP agent will return the actual value upon successful set or get
operation. Upon failure, the SNMP agent will return an error if value is set
our of range, or the agent is not able to get or set the value or the user
does not have access rights to the selected parameter.
3.3.32 Link Configuration Wizard
User Access Level: Level 2
Figure 3-40. Link Configuration Wizard
3.3.32.1 Link Wizard Description
This screen enables the user to configure Framer and ODU related parameters.
The entire Framer and ODU configuration is divided across many pages, the first
of which is shown in Figure 3-40. The pages are:
1. ODU op-mode page – To select ODU operation mode.
2. IDU op-mode page – To select IDU operation mode.
3. ODU configuration page – To configure ODU type, polarization, alignment
mode and starting TX power.
4. ODU channel plan page – To select channel number for ODU.
5. Summary page – Displays all parameter values as selected by the user
from the proceeding pages. Upon pressing the “update” button, all Framer
and ODU parameters are updated.
