User Interface Manual
© Copyright 2006 Microwave Data Systems Inc. All Rights Reserved
3-16
MDS FIVE Series
05-4574A01, Rev. C
c. Auth Trap Enable
6. The page is refreshed and displayed with the updated or current/present
values.
7. If parameters are not updated with entered values, the values entered may
be invalid.
3.3.4.4 SNMP Configuration
1. Select a parameter from the MIB section
ccmSDIDUSysCfgNetworkSNMP.
2. Use the SNMP GET command to get the value of the required parameter.
3. Use the SNMP SET command to set the value of the required parameter.
4. The SNMP agent will return the actual value upon successful set or get
operation. Upon failure, the SNMP agent will return an error if the value set
is out of range, or the agent is not able to get or set the value, or the user
does not have access rights to the selected parameter.
3.3.5 Syslog Configuration
User Access Level: Level 3
Figure 3-9. Syslog Configuration.
3.3.5.1 Description
Figure 3-9 shows the screen used to configure the following Syslog related
parameters:
1.
Syslog IP
- Enter Syslog IP Address for the system. If unsure contact your
network administrator.
2.
Syslog Facility
- Select Syslog facility for the system. If unsure contact
your network administrator.
