User Interface Manual
© Copyright 2006 Microwave Data Systems Inc. All Rights Reserved
3-60
MDS FIVE Series
05-4574A01, Rev. C
3.3.32.2 WEB Configuration
1. Navigate to and click on the “Link configuration” link in the left panel.
2. Select ODU op-mode and click the “next” button.
3. Select IDU op-mode and click the “next” button. In the case of East-West
mode, two independent IDU op-modes can be selected.
4. Select ODU type, Polarization, and Alignment Mode. Enter Starting TX
Power and press the “next” button.
5. Select/Enter ODU Channel Number and press the “next” button.
6. All the above selected parameters are displayed in the summary page.
Verify all values and press the “update” button. To reconfigure, click the
“redo” button in summary page.
7. After pressing the “Update” button, a new page will display the status of
the link configuration.
Note
1. A single set of Framer and ODU parameters will be
displayed for the “standard” ODU operational mode.
2. A single set of Framer parameters and two sets of ODU
parameters will be displayed for the “Protected” ODU op-
mode.
3.
Two sets of Framer and ODU parameters will be displayed,
if the ODU op-mode selected on the first page of the wizard
is “East-West”
.
Warning
To configure the Framer and ODU related parameters, a standard
IO card and modem should be configured and present. Otherwise
an error message will be displayed.
Note
In the Link Configuration Wizard, use only “back”/ “next” button
given in the web page to move to previous/next page.
Do not
use the browser back button
.
Note
If the selected parameters on the current page are not supported
by the terminal, an error message will be displayed on the next
page. To correct the error, go back to the previous page and
select a different value for that parameter.
