3
Configuring RADs and mSAN Connections
3-11
Example Configuration and Procedures
Example Configuration and Procedures
This section provides a specific example of procedures to configure a
SAN Router for a RAD, as well as an mSAN consisting of an Fibre
Channel switch and attached storage (
Figure 3-4
).
Figure 3-4
Connecting to Fabric and FC Device
The configuration in
Figure 3-4
on page 3-11 shows both the SAN
Router and the Fibre Channel switch with no pre-configured zones.
Port 4 of a SAN Router will be connected to a port on the Fibre
Channel switch. The FC server is connected to port 3. The FC WWN
of the HBA in the server is 0x10000000C9232E47. There is a JBOD
connected to the FC switch, which has six disks with WWNs as
shown in the figure. This section describes this sample configuration
using R_Ports.
To create the port configuration, follow these instructions:
1. Make sure the SAN Router is
not
connected to the FC switch.
2. Start the Element Manager for that SAN Router to configure an
R_Port.
Summary of Contents for Eclipse 2640 SAN
