McDATA Eclipse 2640 SAN, Administration And Configuration Manual

Page: 28 / 276

2
2-4
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Setting Parameters Through the CLI
3. Power up the terminal. Press the
Enter
key to display the CLI
prompt.
4. Type
modify
at the Access Mode prompt. This is case-sensitive.
Read is for read-only; modify is for read-write.
5. Type your password at the Password (community string)
prompt. Use
private
as the password and press
Enter
.
6. Set the management port IP address with the following
command:
set mgmt portadd <IP address><subnet mask>
where:
• IP address = IP address of the management port
• subnet mask = subnet mask of the management port.
7. Enter a permanent route for a network management station using
the command:
set mgmt permroute <addr><mask><gateway>
where:
• address = IP address of the network management subnet. This
IP address is used to add a static route to the SAN Router’s
route table. This is required by the management station if its
on a different subnet than the 10/100 interface.
• mask = subnet mask of the network management subnet.
• gateway = IP address of the next hop IP gateway. The gateway
is a directly reachable IP router to which management traffic
should be forwarded.
8. To save the configuration, at the command prompt enter:
save
Parameter Setting
Bits per second 9600
Data bits 8
Parity bits None
Stop bits 1
Flow Control None