![background image](http://html1.mh-extra.com/html/lutron-electronics/radiora-ra-sbt-chr/radiora-ra-sbt-chr_setup-and-installation-manual_1950663095.webp)
Section 8 -
Additional Info
Setup Guide for the RadioRA Chronos System Bridge
95
Ensure that the Chronos
TM
System Bridge is
not in Activate Controls Mode, or the ACTI-
VATE REPEATER LED or ACTIVATE CON-
TROLS LED on any Repeater is
NOT ON
before proceeding. If either LED is ON, press
the corresponding button until it's LED turns
OFF (approximately 3 seconds).
Dimmers
Returning a Dimmer to Default Factory Settings will permanently delete all current programming informa-
tion.
Do not do this unless you are sure that it is necessary.
For more information call the
Lutron
Technical Support Center.
Returning Components to Default Factory Settings
Step 1
Turn FASS
TM
switch OFF
Move the Front Accessible Service Switch
(
FASS
) to the OFF position, or unplug Dimmer
if it is a Lamp Dimmer.
If the LEDs chase downward, continue
with Step 3, then repeat Steps 1-3
again.
Step 2
Turn FASS switch back ON
Step 3
Return to Default Factory
Settings
While the LEDs are chasing upward, simulta-
neously press and release the lower rocker
and the paddle switch.
The light that the Dimmer controls will turn ON
and OFF a few times indicating that the
Dimmer has been returned to Default Factory
Settings. The Dimmer will turn on to 50%
when the process is complete.
Press and hold the raise rocker and the pad-
dle switch while turning the
FASS
switch ON
(or plugging Lamp Dimmer in) until the LEDs
begin to chase upward.