Setup Guide for the RadioRA Chronos System Bridge
32
Section 3 - Button Programming
Local Button Programming
Setting Light Levels/GRAFIK Eye
®
and GRAFIK RA
®
Scene
Selection for Local Buttons
Lighting Zone Controls assigned to each button may be set to desired light levels to fit the mood or activity pro-
grammed. Dimmer light levels default to 100% for ROOM Buttons and 50% for SCENE Buttons. Switches default
to ON and
GRAFIK Eye/GRAFIK RA
Control Units default to Scene 1. For an overview of the Master Control
programming process, refer to page 25.
Step 1
Begin setting light
levels/selecting GRAFIK Eye
and GRAFIK RA scenes
Simultaneously press and hold the 1st and 5th
buttons in the right most column until the
upper right LED begins to blink (approximately
3 seconds).
Step 3
Set light levels for Dimmers
and Switches
Go to any
assigned
Dimmer. Adjust this
Dimmer’s programmed light level for the
selected button using the dimming rocker. For
SCENE Buttons, turn the Dimmer OFF if it is
to be turned OFF when this button is pressed.
Tabletop Master
Wall Master
OR
Upper right LED blinks.
Step 2
Select a Button
Press and release the button that you want to
program. Its LED will begin to blink.
Note:
See Application Note #48 for details on
selecting Scenes 5-16.
Step 4
Select a GRAFIK Eye/GRAFIK
RA scene
Lighting Zone Controls that have been assigned to
that button will turn ON. Controls not assigned to that
button will turn OFF.
ALL ON
ALL OFF
Go to any
assigned GRAFIK Eye/GRAFIK
RA
Control Unit. Select from pre-programmed
scenes (1 through 4) by turning that scene
ON. For SCENE Buttons, select the Off Scene
if the Control Unit is to be turned off when this
button is pressed.
Go to any
assigned
Switch. For SCENE
Buttons, turn the Switch OFF if it is to be
turned OFF when this button is pressed.
