![background image](http://html1.mh-extra.com/html/lutron-electronics/radiora-ra-sbt-chr/radiora-ra-sbt-chr_setup-and-installation-manual_1950663102.webp)
Section 8 -
Additional Info
Setup Guide for the RadioRA Chronos System Bridge
102
Returning Components to Default Factory Settings
Chronos
TM
System Bridge
Returning a
Chronos
System Bridge to Default Factory Settings will
permanently delete all current pro-
gramming
information. If the
Chronos
System Bridge is the main repeater in one system, or bridging two
systems, return all other devices to Default Factory Settings before returning the
Chronos
System Bridge
to Default Factory Settings.
DO NOT do this step unless you are absolutely sure it is necessary.
For
more information call the
Lutron Technical Support Center.
Step 1
Begin Returning to Default
Factory Settings
Press and hold
and
. Continue to hold
the buttons for approximately 4 seconds.
Do not release the buttons. The following
screen will appear:
Are you sure?
Return to default
Cancel
Yes
factory settings?
Step 2
Complete Returning to Default
Factory Settings
To cancel the operation, simply release
and/or or
press “Cancel” (
button).
To complete the process of returning the
Chronos
System Bridge to Default Factory
Settings, continue to hold
and
, and then
press “Yes” (
button).
The
Chronos
System Bridge will reset and
return to the
Chronos
Configuration screen.
Chronos Configuration
Main Repeater
Bridge Systems
RS-232 Interface
Back
Done
No
No
No
Are you sure?
Return to default
Cancel
Yes
factory settings?
Are you sure?
Return to default
Cancel
Yes
factory settings?
Ensure that the ACTIVATE REPEATER LED
or ACTIVATE CONTROLS LED on any
Repeater is
NOT ON
before proceeding. If
either LED is ON, press the corresponding
button until it's LED turns OFF (approximately
3 seconds).