![background image](http://html1.mh-extra.com/html/lutron-electronics/radiora-ra-sbt-chr/radiora-ra-sbt-chr_setup-and-installation-manual_1950663018.webp)
Setup Guide for the RadioRA Chronos System Bridge
18
Section 2 - System
Activation
The
Chronos
System Bridge will display the
Chronos
Configuration screen
when powered for the first
time or whenever the unit is returned to factory
defaults. This screen is also accessible via the
Main
Menu
.
Use
and
to change the value of the selected
setting. Use
and
to move to the next / previous
setting.
Step 1
Go to the Chronos System
Bridge Configuration Menu
Initial Chronos
TM
System Bridge Configuration
Setting the Initial Chronos System Bridge Configuration
Chronos Configuration
Main Repeater - - - - - - -
Bridge Systems - - - - - -
RS-232 Interface - - - - -
Help
Done
No
No
No
Step 2
Configure the Chronos
System Bridge
Modify the settings based on how the
Chronos
System Bridge will be used in the system. The set-
tings are as follows:
Main Repeater
Set this value to “Yes” if the
Chronos
System
Bridge will be the Main System Repeater. This
setting can only be changed later by returning the
Chronos
System Bridge to factory defaults.
Note:
In
order to bridge systems,
Main Repeater
must be
set to “Yes”. The
Chronos
System Bridge will
automatically set
Main Repeater
to “Yes” when
Bridge Systems
is set to “Yes”.
Bridge Systems
Set this value to “Yes” if the
Chronos
System
Bridge will be used to bridge two RadioRA
®
sys-
tems. Otherwise, leave this value “No”. This setting
can be changed from “No” to “Yes” later, if desired;
however, this setting can only be changed from
“Yes” to “No” by returning the
Chronos
System
Bridge to factory defaults.
Step 3a
Accept the Chronos System
Bridge Configuration
Once the desired settings have been selected,
press
“Done” (
button).
If the
Chronos
System Bridge is configured as the
Main Repeater, it will then initialize by acquiring
house addresses and master control addresses.
Initializing System
Acquiring House Code - Pass
Acquiring Addresses - - Wait
Initializing System
System Initialized
successfully. Press
OK to continue.
RS-232 Interface
Set this value to “Yes” if the RS-232 interface will
be used for communication to other systems. This
setting can be changed later, if desired.
Note:
The Time Clock is always active. To use the
Chronos
System Bridge as a Time Clock only, leave
all configurations at “No” and go to Step 3b.