![background image](http://html1.mh-extra.com/html/lutron-electronics/radiora-ra-sbt-chr/radiora-ra-sbt-chr_setup-and-installation-manual_1950663087.webp)
Section 8 -
Additional Info
Setup Guide for the RadioRA Chronos System Bridge
87
Using FLASH Mode
FLASH Mode is used to verify that a Control has been activated correctly.
Note:
If the Chronos
TM
System Bridge
is not set up as a Main Repeater, this option will not be available on the
Chronos
System Bridge.
Diagnostic Tools
Step 1
Enter FLASH Mode
Press and hold the FLASH button on any
Repeater until the green FLASH LED turns
ON (approximately 3 seconds).
Main Menu
System Setup
Diagnostics
Use to
highlight
Flash Mode
. Use
to
set
Flash Mode
to
Yes
.
Diagnostics
Flash Mode - - - - - - - - Yes
Beep Mode - - - - - - - - - No
System Beep Mode - - - No
Back
Help
Green FLASH LED on all Repeaters will turn
ON.
Step 2
Check all Controls
Lighting Zone Controls, if activated, will flash
the light(s) they control. Make note of any
Lighting Zone Controls that are not activated.
Master Controls and Interfaces, if activated,
will flash all their LEDs. Make note of any
Master Controls or Interfaces which are not
activated.
From the Chronos System Bridge (as a Main
Repeater only):
From a Repeater: