![background image](http://html1.mh-extra.com/html/lutron-electronics/radiora-ra-sbt-chr/radiora-ra-sbt-chr_setup-and-installation-manual_1950663091.webp)
Section 8 -
Additional Info
Setup Guide for the RadioRA Chronos System Bridge
91
Using System BEEP Mode
System BEEP Mode is used to verify that the Chronos
TM
System Bridge and all Repeaters in a system can 'hear'
a particular control.
Note:
If the
Chronos
System Bridge is not set up as a Main Repeater, this option will not be
available.
Diagnostic Tools
Step 1
Enter System BEEP Mode
Main Menu
System Setup
Diagnostics
Use to
highlight
System Beep Mode
. Use
to set
System Beep Mode
to
Yes
.
Diagnostics
Flash Mode - - - - - - - - No
Beep Mode - - - - - - - - - No
System Beep Mode - - -Yes
Back
Help
Step 2
Check a Control
Turn the Lighting Zone Control ON or OFF,
press the ALL ON or ALL OFF button on a
Master Control.
Step 3
Repeater response
The
Chronos
System Bridge and all
Repeaters that can ‘hear’ the control will pro-
duce multiple audible beeps immediately after
the button is pressed.
RF Signal
RF Signal
BEEP
BEEP
Step 4
Exit BEEP Mode
From
Diagnostics
, highlight
System Beep
Mode
. Use
to set
System Beep Mode
to
No
.
Diagnostics
Flash Mode - - - - - - - - -
No
Beep Mode - - - - - - - - - No
System Beep Mode - - - No
Back
Help