![background image](http://html1.mh-extra.com/html/lutron-electronics/radiora-ra-sbt-chr/radiora-ra-sbt-chr_setup-and-installation-manual_1950663020.webp)
Setup Guide for the RadioRA Chronos System Bridge
20
Section 2 - System
Activation
Activating the System
Step 1
Go to System Setup
Main Menu
System Setup
Note:
If the
Chronos
System Bridge is configured to
bridge systems, the
Main Menu
will contain a
System 1 Setup
and a
System 2 Setup
. These
steps should be repeated for both systems.
Step 2
Put the Chronos System
Bridge into Activate Repeater
Mode
From
System Setup
, select
Activate Aux
Repeaters
.
The number of repeaters currently in the system is
displayed. This number will update as new repeaters
are activated.
Step 3
Activate Auxiliary Repeater
Nearest to the Chronos
System Bridge
Press and hold the ACTIVATE REPEATER
button until the green
ACTIVATE REPEATER LED begins to flash
(approximately 3 seconds).
Green ACTIVATE REPEATER LED will stay
on when Repeater has been activated.
System Setup
Activate Aux Repeaters
Activate Controls
Address Usage
Diagnostics
Back
Help
Activate Aux Repeaters
Begin Activating Aux
Repeaters in System 1
Auxiliary Repeaters - - - - 0
Help
Done
Step 4
Activate remaining Repeaters
Repeat Step 3 for each remaining Repeater, starting
with the next closest Repeater (maximum of 3
Auxiliary Repeaters).
If the ACTIVATE REPEATER LED on an
Auxiliary Repeater turns orange, consult the
Troubleshooting Guide.
?
Activate Auxiliary Repeaters
This procedure needs to be performed only if the Chronos
TM
System Bridge is configured as a Main Repeater. If
the
Chronos
System Bridge is not configured as a Main Repeater, skip this procedure. Repeaters must be in
their permanent location in order to be activated. Note: Additional Auxiliary Repeaters (up to 3 Repeaters total
per system) can be added to a system to increase range and improve reliability.
Ensure all system devices are powered up and operating prior to adding any Auxiliary Repeaters.