L-DALI User Manual
163
LOYTEC
Version 5.2
LOYTEC electronics GmbH
To remove an assignment from an object select the corresponding entry and press the
Unassign
button. The entry in the object list will become unassigned again and the DALI
device will be moved to the scan results list to the right.
To identify a device in the scan results list select the corresponding row and click on the
Wink
button. The duration of the
Wink
action can be chosen in the drop down box besides
the button. When a device winks it dims between its minimum and maximum value for the
specified wink duration.
Tip!
Use auto assign if you do not care about the assignment of a specific device. This is
typically the case if you are using the on-line work flow (do not prepare DALI installation
off-line) and you do not use the Lamp Actuator objects to control the lights (rather use
Group or Channel Actuator objects).
7.5.2 DALI Groups Tab
The DALI Groups tab is shown in Figure 151. It is used to assign DALI ballasts to groups
and setup group names.
Similar to the DALI Installation tab the drop down box in the top left corner of the tab
allows you to choose the DALI channel to work with. Below there is a table which contains
one row for each DALI ballast (64) and one column for each DALI group (16). To
add/remove a device to/from a group check/uncheck the check box where the corresponding
row and column are crossing. The default name of a group (e.g. “Group 00”) can be
changed by double clicking on it.
Figure 151: DALI Groups tab.
The checkbox
Recover group information from devices
allows keeping the group
configuration in the devices (ignoring the group configuration defined in the LINX
Configurator). It is automatically unchecked if the group configuration is changed with the
LINX Configurator.
7.5.3 DALI Channels Tab
The DALI Channels tab is shown in Figure 152. It is only available if the device is equipped
with more than one DALI channel. This tab is used to change channel names and to
configure DALI channel bridging.
