Kurzweil PC3, Musician'S Manual

Page: 156 / 308

7-36
Setup Mode
The RIBBON Page
The RIBBON Page
The RIBBON page lets you define the controller assignment for the PC3’s ribbon controller. The
optional Ribbon controller senses movement when you press on it and move your finger left or
right; this creates numerous possibilities for controlling pitch, volume, panning, crossfades
between zones, or any other uses you might imagine.
The optional Ribbon controller can be used as a single long controller, or it can be divided into
three separate sections, each with its own controller assignments (this is done on the RIBCFG
page). The two small arrows above the strip indicate the boundaries of the three sections. The
large arrow above the ribbon points to the center of the ribbon, for when the ribbon is
configured in one section.
Note that there are three assignable parameter groups on the RIBBON page. When the Ribbon is
set to act as a single section controller, the only parameters that affect its behavior are those of
Section 1 (Sect1). When the Ribbon is set to act as a three-section controller, each parameter
group affects only its respective Ribbon section.
To modify other ribbon parameters, go to the RIBCFG page, which is described on page 7-37.
The RIBBON page parameters are described in Continuous Controllers on page 7-20.
Parameter Range of Values Default
Destination Control Destination List MIDI21
Scale ± 300% 100%
Add -128 to +127 0
Curve Curve List (see text) Lin
Entry Value None, 0 to 127 None
Exit Value None, 0 to 127 None