163
Chapter 4: Repair information
Figure 49
Diagnostics View
3. Type the port number to be tested in the
Targeted Port Number
field.
4. At the
Diagnostic Test
list box, select the
Internal Loopback
option.
5. Click
Start
. The test begins and:
a. The
Diagnostics View
changes to a
Diagnostics - Executing View
.
b. The message
Diagnostics Time Remaining: xx
appears, where
xx
are the seconds remaining in the test. The test takes
approximately 30 seconds.
NOTE:
Click
Stop
at any time to abort the loopback test.
6. When the test completes, the
Diagnostics - Executing View
reverts
to the
Diagnostics View
. Test results appear as
Passed
,
Failed,
or
Test Incomplete
in the message area of the view.
7. Reset the tested port:
a. Select
Ports
and
Reset
from the
Maintenance
menu at any view.
The
Reset View
displays.
b. For the tested port, click (enable) the check box in the
Reset
column. A check mark in the box indicates the port reset
option is enabled.
i1
6M2
008
Summary of Contents for SAN32M-2
