IBM SAN32M-2, Installation And Service Manual

Page: 48 / 312

SAN32M-2 Installation and Service Manual 22
5. Connect the AC power strip to facility power. Power for each hub
switches on when the strip is connected to facility AC power.
6. Inspect the front panel of each hub. Ensure each green Power
light-emitting diode (LED) illuminates.
Rack-mount installation
Perform the following steps to install and configure up to three
Ethernet hubs in a SANC40M cabinet or customer-supplied 19-inch
equipment rack. A pointed instrument (pencil tip or bent paper clip),
#2 Phillips screwdriver, and 1/8-inch Allen wrench are required.
1. Secure one mounting bracket to each side of the first hub as
shown in Figure 9 . Use the two brackets and four pan-head
Phillips screws (8/32 x 0.5-inch) provided.
Figure 9 Mounting bracket installation (Ethernet hub)
2. Position the hub as directed by the customer. Align screw holes in
the mounting brackets with screw holes in the rack-mount
standards.
3. Secure both sides of the hub to the rack-mount standards. Use the
1/8-inch Allen wrench and four Allen-head mounting screws
(10/32 x 0.5-inch) provided.
4. Repeat all previous steps in this procedure for the remaining
hubs.
5. To daisy-chain (connect) the hubs:
i140M016