IBM SAN32M-2, Installation And Service Manual

Page: 73 / 312

47 Chapter 2: Installation tasks
7. Configure Port Settings parameters:
— Bits per second - 115200 .
— Data bits - 8 .
— Parity - None .
— Stop bits - 1 .
— Flow control - Hardware or None .
Click OK . The New Connection - HyperTerminal window displays.
8. At the > prompt, type the user password (default is password )
and press Enter . The password is case sensitive. The New
Connection - HyperTerminal window displays with software and
hardware version information for the product, and a C > prompt
at the bottom of the window.
9. At the C > prompt, type the ipconfig command and press the
Enter
key. The New Connection - HyperTerminal window displays
with configuration information listed:
— MAC Address .
— IP Address (default is 10.1.1.10 ).
— Subnet Mask (default is 255.0.0.0 ).
— Gateway Address (default is 0.0.0.0 ).
— Auto Negotiate .
— Speed .
— Duplex .
Only the IP Address , Subnet Mask , and Gateway Address fields are
configurable.
10. Change the IP address, subnet mask, and gateway address as
directed by the customer. To change the addresses, type the
following at the
C >
prompt and press
Enter
.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is
xxx.xxx.xxx.xxx
, the subnet mask is
yyy.yyy.yyy.yyy , and the gateway address is zzz.zzz.zzz.zzz ,
where the octets xxx , yyy , and zzz are decimals from zero through
255. If an address is to remain unchanged, type the current
address in the respective field.