IBM SAN32M-2, Installation And Service Manual

Page: 136 / 312

SAN32M-2 Installation and Service Manual 110
• AC power distribution for the product failed or AC power was
disconnected.
• The product CTP card failed.
Continue to the next step.
3
Ensure the product is connected to facility power. Inspect the product
for indications of being powered on, such as:
• An illuminated PWR LED (green) or ERR LED (amber).
• Illuminated LEDs adjacent to Fibre Channel ports.
• Noise and airflow from cooling fans.
Is the product powered on?
YES NO
↓
A power distribution problem is indicated. Go to MAP 0100:
Power distribution analysis . Exit MAP.
4
A product-to-PC link problem (Internet too busy or IP address typed
incorrectly) or an Ethernet port failure is indicated.
a. Wait approximately five minutes, then attempt to login to the
product.
b. At the Netsite field (Netscape Navigator) or Address field
(Internet Explorer), type http://xxx.xxx.xxx.xxx , where
xxx.xxx.xxx.xxx is the product IP address obtained in MAP
0000: Start MAP . The Username and Password Required dialog
box appears.
c. Type the user name and password obtained in MAP 0000: Start
MAP and click OK . If the EFCM Basic Edition interface does not
open, wait five minutes and perform this step again.
Is the EFCM Basic Edition interface operational?
NO YES
↓
The Internet connection is restored. Exit MAP.
Failure of the Ethernet port is indicated. Replace the switch.
Exit MAP.