IBM SAN32M-2, Installation And Service Manual

Page: 157 / 312

131 Chapter 3: Maintenance analysis procedures
c. Select (click) the Speed field and configure the port.
d. Click OK or Activate .
Was the maintenance action successful?
NO YES
↓
The product port is operational. Exit MAP.
Contact the next level of support. Exit MAP.
16
A port is inactive because the port swap configuration is invalid.
Perform a port swap procedure (Element Manager only), ensure the
configuration is valid, and ensure the port address matches the
hardware configuration definition (HCD) of the attached host. Refer to
Swap ports . Exit MAP.
17
As indicated by event codes 506 , 512 , 514 , 515 , or 516 , a port failed
and the optical transceiver must be removed and replaced. Refer to
Customer-replaceable unit: SFP optical transceiver .
• The procedure is concurrent and performed while the product is
operational.
• Replace the transceiver with a transceiver of the same type
(shortwave or longwave) and speed.
• Perform an external loopback test. Refer to External loopback
test (EFCM Basic Edition) or External loopback test (Element
Manager).
NOTE: Event code 514 may generate a call-home event that incorrectly
indicates a CTP card failure. Although the optical socket on the CTP card
may have failed, replace the transceiver and verify operation. If a failure is still
indicated, replace the switch. When event code
514 is indicated, ensure a
replacement transceiver and switch are available.
Was the maintenance action successful?
NO YES
↓
The product port is operational. Exit MAP.
Contact the next level of support. Exit MAP.