IBM SAN32M-2, Installation And Service Manual

Page: 104 / 312

SAN32M-2 Installation and Service Manual 78
e. Select from the drop-down list in the Type column to configure
the port type. Available selections are fabric port ( F_Port ),
expansion port ( E_Port ), generic port ( G_Port ), generic mixed
port ( GX_Port ), and fabric mixed port ( FX_Port ).
f. Select from the drop-down list in the Speed column to
configure the port transmission rate. Available selections are
auto-negotiate between 1.0625 and 2.1250 Gbps operation
(
Negotiate ), 1.0625 Gbps operation ( 1 Gb/sec ), and 2.1250
Gbps operation( 2 Gb/sec ).
g. The NPIV feature must be installed to allow multiple Fibre
Channel addresses to be assigned to an N_Port. Refer to Install
PFE keys (optional) for instructions. Type the desired value
( 1 through 256 ) in the NPIV Login Limit column.
h. Click the check box in the Port Binding column to enable or
disable the feature (default is disabled). A check mark
indicates binding is enabled and the port can connect only to a
device with a WWN listed in the
Bound WWN column.
i. Type the WWN or nickname of the device attached to the port
in the Bound WWN column.
• If port binding is enabled and a WWN or nickname
appears in the Bound WWN column, only the specified
device can connect.
• If port binding is enabled but no WWN or nickname
appears in the Bound WWN column, no device can connect.
• If port binding is disabled, any device can connect.
2. Click Activate to save the information and close the dialog box.
Configure SNMP
Perform this procedure to configure names, write authorizations,
addresses, and UDP port numbers for SNMP trap message recipients.
To configure recipient workstations:
1. Select SNMP Agent from the Configure menu at any view. The
Configure SNMP dialog box displays ( Figure 40 ).