IBM SAN32M-2, Installation And Service Manual

Page: 39 / 312

13 Chapter 1: General information
• Automatic notification of significant system events (to support
personnel or administrators) through e-mail messages or the
call-home feature.
NOTE: The call-home feature is not available through the EFCM Basic
Edition. The call-home feature may not be available if the EFCM Basic
application is installed on a customer-supplied platform.
• SNMP management using the Fibre Channel Fabric Element MIB,
Transmission Control Protocol/Internet Protocol (TCP/IP) MIB-II
definition (RFC 1157), or a product-specific private enterprise
MIB that runs on the switch. Up to six authorized management
workstations can be configured through the EFCM Basic Edition
interface or Element Manager application to receive unsolicited
SNMP trap messages. The trap messages indicate product
operational state changes and failure conditions.
• Optional SNMP management using the Fibre Alliance MIB that
runs on the management server. Up to 12 authorized
management workstations can be configured through the SAN
management application to receive unsolicited SNMP trap
messages. The trap messages indicate operational state changes
and failure conditions.
Tools and test equipment
This section describes tools and test equipment that may be required
to install, test, service, and verify operation of the product and
attached management server. These tools are supplied with the
product or must be supplied by service personnel.
Tools used with the product
The following tools may be used to service the product:
•
Door key -
A door key with 5/16-inch socket ( Figure 4 ) may be
required to open front and rear doors of the equipment cabinet. A
5/16-inch socket wrench may also be used.