IBM SAN32M-2, Installation And Service Manual

Page: 153 / 312

127 Chapter 3: Maintenance analysis procedures
— Select Open Fabric 1.0 if the product is attached to directors
or switches produced by open-fabric compliant original
equipment manufacturers (OEMs).
d. Click OK or Activate .
Was the maintenance action successful?
NO YES
↓
The product port is operational. Exit MAP.
Contact the next level of support. Exit MAP.
6
A loopback (wrap) plug is connected to the port with no diagnostic
running. Remove the plug from the port receptacle. If directed by the
customer, connect a fiber-optic jumper cable attaching a device to the
product.
• If the port is operational with no device attached, both LEDs
adjacent to the port extinguish and the port state is
No Light .
• If the port is operational with a device attached, the green LED
illuminates, the amber LED extinguishes, and the port state is
Online .
Was the maintenance action successful?
NO YES
↓
The product port is operational. Exit MAP.
Contact the next level of support. Exit MAP.
7
An ISL connection is not allowed because E_Port capability is
disabled. Install the full-fabric PFE key to enable E_port capability.
Refer to
Install PFE keys (optional) (EFCM Basic Edition) or Task 15:
Configure PFE key (optional) (Element Manager). Exit MAP.
8
The connection timed out because of an unresponsive device or an
ISL security violation (authorization failure reject). Check port status
and clean fiber-optic components.
a. Inform the customer the port will be blocked. Ensure the system
administrator quiesces Fibre Channel frame traffic and sets
attached devices offline.