Table 26 Error Codes — Part Code 1005
(continued)
Failure
Level
Severity
Level
Recommended Action
Error Message
Error
Number
Part
Code
2
E
CHA high-speed mode is
specified to unmounted CHA.
The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
An error occurred. If this
problem persists, call HP
technical support.
1127
1005
2
E
Channel speed change is
requested, but Fibre PCB
does not support it. The error
does not occur normally
because it is guarded in the
screen. In the unlikely event
that this error occurs, contact
HP technical support.
An error occurred. If this
problem persists, call HP
technical support.
1128
1005
6
E
Correct the specified contents,
and request again.
You cannot specify the
default nickname when
setting the nickname of a host
group or a host.
1130
1005
6
E
No more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port. Reduce the
number of host groups, and
then retry the operation.
No more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port.
1131
1005
6
E
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
a port.
1132
1005
6
E
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the host mode
because the number of host
modes exceeds the maximum
that can be set in a port.
1133
1005
6
E
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the path because
the number of paths exceeds
the maximum that can be set
in a port.
1134
1005
Remote Web Console Error Codes 107
