HP XP20000/XP24000, Manual

Page: 26 / 448

Table 3 Error Codes — Part Code 0003 (continued)
Failure
Level Severity
Level Recommended Action Error Message Error
Number Part
Code
6 E Correct the specified
contents, and request again. You cannot specify the
default nickname when
setting the nickname of a host
group or a host. 1130 0003
6 E No more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port. Reduce the
number of host groups, and
then retry the operation. No more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port. 1131 0003
6 E The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again. Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
a port. 1132 0003
6 E The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again. Failed to set the host mode
because the number of host
modes exceeds the maximum
that can be set in a port. 1133 0003
6 E The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again. Failed to set the path because
the number of paths exceeds
the maximum that can be set
in a port. 1134 0003
2 E When PORT information
(Fibre Address/Fibre
Topology/Channel Speed) is
set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support. An error occurred. If this
problem persists, call HP
technical support. 1135 0003
2 E When CHA high-speed mode
is set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support. An error occurred. If this
problem persists, call HP
technical support. 1136 0003
6 E The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again. Failed to form a LUSE volume
because the number of LUSE
volumes exceeds the
maximum that can be set in
a disk array subsystem. 1137 0003
26 Remote Web Console for Storage System Messages and Error Codes