Hinowa LightLift 15.70 3S, Technical Course Booklet

Page: 31 / 137

31
The prevention system works with 1 st booms opening microswitch installed
behind the aerial part valveblock, and turret rotation proximity sensor installed
on the slew ring.
For further details check the chapter 9.5 SENSORS AND DEVICES NOT
COMMUNICATING THROUGH CAN-BUS.
NOTE: The engine carter contact prevention system is not activated while
operating directly from valveblock levers of the ground control position.
NOTE: Safeties by-pass procedure does not by-pass engine carter contact
prevention system.
6.
PEDAL (OPTIONAL)
On some countries is required the utilization of the pedal to allow the machine
movements controlled the basket, this function grant further control avoiding
unintentional movements.
This option can be enabled or disabled on all of the machines even for those
countries where it’s not required.
To enable this further control the pedal must be installed in the basket.
When activated, the pedal must be pressed and kept pressed before to operate
the machine from the basket otherwise the movements are avoided, when a
joystick is moved and the pedal has not been pressed the operator will be
inform ed by the display error message “PEDAL NOT PRESSED” appearing on
position n.7.
With pedal pressed, after 8 seconds that the operator has not moved any
joystick the pedal must be released and pressed again.
If pedal is pressed it’s not possible to ignite the motors.
“PEDAL NOT
PRESSED” ICON
PEDAL IN THE BASKET