Hinowa LightLift 15.70 3S, Technical Course Booklet

Page: 78 / 137

78
The here above picture shows the SERVICE menu main display, by the lower
row it’s possible to identify the installed software version and the machine
model settled (Diesel RPM or Lithium).
Fr om SERVICE menu pressing button from n.1 to n.8 it’s possible to enter into
several menus as for instance pressing button n.1 display will show the INPUT
menu. Pressing button n.9 (ESC) brings back to the main display.
From SERVICE menu it’s possible to en ter into other menu and under menus
NOTE: While into the SERVICE menu it’s possible to use all of the joysticks and
motors buttons, it’s not possible to use outriggers and tracks widening buttons.
10.1.2 INPUT
This menu visualizes the current status of all the devices giving an input signal
to the ECM1, it’s so possible to check eventual changes of status.
The device status visualized depends on the signal received by the ECM1 so
that it depends on the device itself but also on the connections.
The picture aside shows for instance the status of the first device of INPUT
menu. Pressing button n.1 (PREV) brings back to the previous device of the
list, pressing button n.2 (NEXT) brings to the next one. Pressing button n.9
(ESC) brings back to the SERVICE menu main display.
Here follows the INPUT list with their meanings.
ST1 GND A
ON
1 PREV
2 NEXT
9 ESC
DEVICE
INPUT
STATUS
MENU
1 1 INPUT
2 2 LANGUAGE
3 3 ERRORS
4 4 RAMP
5 5 CURRENT
6 6 W.HOURS
7 7 SETUP
8 8 JOYSTICK
9 9 ESC
V 1.1
L1570 D.RPM
Software installed version

1.2
Machine model settled

LL1570 Diesel RPM
MENU
1 INP ->OUT
2 LANGUAGE
3 ERR ->COD
4 RAMP
5 CURRENT
6 W.HOURS
7 SETUP
8 JOYSTICK
9 ESC
V 1.2
LL1570D.RPM