Hinowa LightLift 15.70 3S, Technical Course Booklet

Page: 24 / 137

24
When machine is not closed and
aligned, if operator try to move an
outrigger display will remind that
machine need to be closed and aligned
by the error message aside.
NOTE: If during the stabilization the photocells lose the signal, for example due
to movements in progress,
the “MACHINE CLOSED AND ALIGNED” icon
disappears but the movements will continue for a while even if signal doesn’t
come back.
4.2.1 AUTOMATIC STABILIZATION
To be able to automatically stabilize the machine it must be closed and aligned,
to automatically stabilize the machine it has to be press remote control button
n.7 “AUTO - STABILIZATION” and keep it pressed until that display shows “OK”.
AUTO-STABILIZATION procedure sets all the outriggers at the ground and
automatically levels the machine on both axles “X” and “Y”, w hile the procedure
is in progress the display shows “WAIT” and the outriggers conditions, as
indicated by the following example.
ERROR
“MACHINE
CLOSED AND
ALIGNED”
ICON
“ AUTO-STABILIZATION ”
BUTTON
PHOTOCELLS
REFLECTOR