Hinowa LightLift 15.70 3S, Technical Course Booklet

Page: 110 / 137

110
7 Press button n.9 (ESC) and then turn OFF the main key
8
T urn ON again the main key and verify by INPUT “INCLIN. X” and “INCLIN.
Y“ that calibration is correct by checking the variation at different machine
inclinations
APPENDIX 2 - LOAD CELL BOARD (ECM3) CALIBRATION
After having replaced the master board (ECM1) or the load cell board (ECM3)
or having replaced the load cell sensor it’s necessary to calibrate the “0” of the
load cell system, by this procedure the calibration parameters relevant to the
load cell sensor installed will be memorized on the ECM1.
Being possible difference between one load cell sensor and another it’s
necessary to calibrate ECM1 with the load cell sensor installed on the machine
and not with another.
The load sensor system reset must be done with the basket unloaded from its
support.
The reset
the load sensor system consist into saving the value “0”, done without
the basket, here follows the calibration procedure:
1
Turn ON the main key and stay out from the basket with remote control on
hands
2 Press button n.6 (SERVICE) and then press button n.7 (SETUP)
3 Press button n.5 (PASSWORD). The display will ask for the password
4 Inserting password 6138 the display will confirm with
“OK”
5 Press button n.9 (EXIT) and then button n.7 (LOAD
SENS), the display will than visualize the page here
aside
6 With the basket unloaded form its support press button
n.3 (CALIB) and verify that display indicates “OK” . In
case of the basket is still loaded on its support this page
will display “NOT READY” instead of “READY” and reset
will not be possible
7 Press button n.9 (ESC) and then turn OFF the main key
8
T urn ON again the main key and verify by INPUT “LOAD A” and “LOAD B“
that calibration is correct by checking the variation at several basket loading
condition, the difference between LOAD A and LOAD B values should be less
than a certain value
LOAD SENS.
CALIBRATI
ON
MACCHINA:
NOT READY
3 CALIB.
9 ESC