Furuno GD-280, Operator'S Manual

Page: 70 / 280

2-32
6. Press
[←]
to select By cursor. The following message appears.
7. Operate the trackball to place the +cursor where to shift the chart.
8. Press the [ENT] key. The "offset" icon ( ) appears at the bottom of the display.
9. Press the [MENU] key several times to close the menu.
Note : To remove the offset, select Off at step 5 in the above procedure.
2.9.2 Offsetting chart position by latitude and longitude values
1. Press [MENU], [0], [1] to display the Plotter Display [Chart Attributes] menu, and select Page
4.
2. Press
[↓]
to select Chart Pos. Offset.
3. Press
[→]
to select On.
4. Press
[→]
to select By L/L Position.
5. Enter latitude offset value. If it is 13.097'N, for example, press [1], [3], [0], [9], [7], ( ). Use
the key to switch coordinates if necessary.
6. Enter longitude offset value. If it is 08.169'E, for example, press [0], [8], [1], [6], [9], ( ). Use
the key to switch coordinates if necessary.
7. Press the [ENT] key.
8. Press the [MENU] key several times to close the menu.
Place +cursor and press ENT.
Other Keys: Escape