Furuno GD-280, Operator'S Manual

Page: 268 / 280

A-10
5. Plotter Display Error Messages
Below is a list of error messages shown on the plotter display, arranged in alphabetical order.
Message Meaning Remedy
All waypoints are set to SKIP. All route waypoints in a "chained"
route are set to "skip." Restore appropriate waypoints as
necessary.
Beacon Receiver is not built in. Internal beacon receiver selected
on menu and system is not
equipped with the built in GPS
receiver. Select external GPS receiver on
the GPS menu.
Cannot calculate L/L data. Could not convert LA, LC or
Decca to latitude and longitude
position, because estimated L/L
position is too inaccurate, when
you attempted to enter mark, line,
target point or waypoint. Check navigator.
Cannot copy to the same source
medium. Selected target medium is the
same as source medium, when
attempting to copy data. Select different target medium.
Cannot delete. Could not delete a file. Try again.
Cannot find file. File could not be found when
replacing floppy disk in logger
recording, replaying; file selected
for display from memory card
does not exist.
Cannot format. Could not format medium. Try again. If formatting fails again,
replace medium.
Cannot load data. Could not load data when
replaying a file. Try to replay data again.
Cannot record log, Remove
write-protection of FD. Could not record logger data to
floppy disk because it is write
protected. Release write protection.
Cannot record log. Improperly formatted floppy disk
used to record logger data. Insert formatted floppy disk and
try again.
Cannot replay log. Damaged floppy disk used to
replay logger data. Replace floppy disk.
Cannot replay while destination is
selected. You attempted to playback data
when a destination is set.
Cannot specify area when display
mode is other than NU/TM. "Off Screen" or "On Screen"
specified when attempting to
erase track, marks or file when
mode is other than NU/TM. Switch to NU/TM mode and try
again.
Could not save. Memory space is
not enough. Could not record data because of
insufficient space on medium. Replace medium and try again.
Data Logger replay stopped Appears when logger recording
or replaying is attempted while
data logger replay is stopped.
Distance is too long, cannot be
registered. You attempted to register a
mark/line, target point or waypoint
by range and bearing but no
latitude and longitude position
could be found because the
distance is too far away. Reenter position.