Fukuda Denshi DSL-8001, Operation Manual

Page: 172 / 252

7 － 6
Battery Operation
Using the battery for operating the DSL-8001 allows monitoring at places where
AC power source is not available such as during in-hospital patient transportation.
One (1) battery can be installed inside the unit.
Also, the DSL-8001 will automatically switch to battery operation for the following
cases.
 When a sudden electricity failure occurs.

When the AC power cable is accidentally disconnected.
WARNING
The battery installation will be performed by our service
representative. Users should not attempt the procedure as
it may result in electric shock or malfunction to the
equipment.
CAUTION
 The battery operating duration will shorten depending on
the number of NIBP measurement performed, etc.
 When using a new battery, or a battery which was stored
for a long period of time, the operating duration may be
short at beginning of usage. In such case, repeating
charging and battery operation for 2 or 3 times will bring
out the original performance.
To Charge the Battery
Connecting the power cable to the hospital grade outlet with the battery installed
will start the charging. During charging, the battery LED lights in orange. When
the LED turns to green, the charging is complete.
Operating the monitor with the AC supply allows monitoring the vital information
while charging the battery.
Battery Pack Type
Charge Duration
(from empty to full)
Battery Operation
BTO-002 (L Size) 12 hours 5 hours
BTO-003 (M Size) 8 hours 3 hours
BTO-004 (S Size) 4 hours 1 hour
CAUTION
 Repeated charging within short duration will cause the
battery temperature to rise and may stop the charging
procedure for safety purpose until the battery
temperature decreases.
 Repeated charging of fully charged battery within short
duration will cause the battery temperature to rise and
degrade the battery.