Fukuda Denshi DSL-8001, Operation Manual

Page: 89 / 252

2 － 39
To Install the Paper
CAUTION
When installing the printing paper, pay attention not to touch the
thermal head or sensor. The temperature of those parts rises
immediately after printing and may cause burn injury. Also, it may
cause failure to the thermal head and sensor.
1. Pull out the printer cover to open the cover.
NOTE
Pay attention when opening the cover as the printing paper may fall
out.
2. Set the printing paper. (OP-050-01TDR)
The printing paper has front and back sides. Refer to the illustration, and
set the printing paper in the correct direction. Make sure that the printing
paper is correctly set in the slot.
3. Close the cover into its initial position. Push in until it locks into place with
a click sound.
Make sure to push the center of the cover to close it properly. If the cover is
pushed from the sides, it will not close properly