Fukuda Denshi DSL-8001, Operation Manual

Page: 30 / 252

xxviii
EMC Guidance
This equipment complies with EN 60601-1-2 (2007)/IEC60601-1-2 (2007).
However, if a portable transmitter or wireless LAN equipment is used extremely
closely, the electromagnetic influence may largely exceed the compliance level
and may cause unexpected phenomenon such as noise interference in the
waveform, etc.
Therefore, this equipment should be used in a location specified by each medical
institution.
If any unexpected noise interference on the waveform or failure to the peripheral
device occurs, stop using the equipment and follow the instruction of the
technician.
The following is the information relating to EMC (Electromagnetic Compatibility).
(When using this equipment, verify that it is used within the environment specified
below.)
Compliance to the Electromagnetic Emissions
The DSL-8001 system is intended for use in the electromagnetic environment
specified below.
Emissions Test Compliance Electromagnetic Environment - Guidance
RF Emissions
EN 55011
Group 1
The equipment uses RF energy that is necessary for
the internal functioning of the equipment itself.
Therefore, its RF emissions are very low and are not
likely to cause any interference in nearby electronic
equipment.
RF Emissions
EN 55011
Class A
The equipment is suitable for use in all
establishments other than domestic and those
directly connected to a low-voltage power supply
network which supplies buildings used for domestic
purposes.
Harmonic
Emissions
IEC 61000-3-2
Class A
Voltage
Fluctuations/
Flicker Emissions
IEC 61000-3-3
Complies