Fukuda Denshi DSL-8001, Operation Manual

Page: 27 / 252

xxv
CAUTION
 The ventilator operation should be performed by a
well-trained or authorized person.
 When connecting this equipment and the ventilator, use only
the specified connection cable.
 Verify that this equipment and the ventilator are properly
connected.
 When connecting the cable, verify that the main power of this
equipment and the ventilator are OFF.
 In Communication Setup, the same function cannot be set
to multiple ports. Only one model type of Ventilator can be
connected.
 If the ventilator status is not displayed in green , ventilator
alarm will not be generated even if the ventilator is in alarm
status.
 Check the communication status of this unit and the
ventilator occasionally after monitoring starts. Make sure that
ventilator alarm is not generated and ventilator status is
displayed in green
.
Precautions about Use of the SpO
2
Sensor
DANGER
Burn Risk when Using the SpO
2
Sensor
In SpO
2
monitoring, always use the sensor/relay cable
specified by Fukuda Denshi. If any other sensor/relay cable
is used, the sensor temperature may increase too high,
place the patient in danger of burns.
If there are any questions regarding the sensor/relay cable
use for SpO
2
measurements of this device, please contact
Fukuda Denshi service representative.
Precautions for Use of NIBP Cuff
CAUTION
This product contains natural rubber latex which may cause
allergic reactions.
(FDA: Medical Alert on Latex Products, “Allergic Reactions to
Latex-Containing Medical Devices”, Food & Drug
Administration, 9200 Corporate Blvd., Rockville, MD 20850,
1991.)
Disposing of Equipment, Accessories, or Components
CAUTION
When disposing of the equipment, accessories, or components,
use an industrial waste distributor. Do not dispose of as ordinary
waste.