Fujitsu Eternus DX200F, User Manual

Page: 237 / 1082

Chapter 2 Component Management
2.6 Add Drive Enclosure
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
237
2.6 Add Drive Enclosure
This function enables DEs to be added without stopping the ETERNUS DX S3 series.
Use ETERNUS Web GUI to install any DEs that are added.
The number of DEs that can be added for each model is as follows:
• ETERNUS DX60 S3 (3.5" CE model)
DE#01
• ETERNUS DX100 S3/DX200 S3
DE#01 - DE#0A
For details on the parameters for this function, refer to "A.2.1 Add Drive Enclosure" (page 780) .
The procedure to expand a DE is as follows:
Procedure
1
Click [Add Drive Enclosure] in [Action].
 The start screen appears.
• The ETERNUS DX200F does not support this function.
• When logged in using a user account with the "Admin" default role, this function is available only with
the ETERNUS DX60 S3/DX100 S3/DX200 S3. To use this function with the ETERNUS DX500 S3/DX600 S3
and the ETERNUS DX8700 S3/DX8900 S3, a user account with the "Maintainer" default role (or
"Maintenance Operation" policy) is required.
• When DE hot expansion is performed, multiple DEs can be added with a single operation.
• 2.5" DEs, 3.5" DEs, and 3.5" high density DEs can be installed in the same ETERNUS DX S3 series (except
the ETERNUS DX60 S3).
• For the ETERNUS DX60 S3 3.5" CE model (hereinafter referred to as "ETERNUS DX60 S3"), only the 3.5" DE
can be added. For the ETERNUS DX60 S3 2.5" CE model, DEs cannot be added.
• Be sure to use authorized expansion parts. If parts other than the expansion parts are used, operation is
not guaranteed.
• This function cannot be used under the following conditions:
- The general status of the ETERNUS DX S3 series is not "Normal"
- For the ETERNUS DX60 S3, DE#01 is already installed (when the status of DE#01 is " Normal")
- For the ETERNUS DX100 S3/DX200 S3, DE#0A is already installed (when the status of DE#0A is "
Normal")
DEs can be added regardless of whether drives are installed or not.