eta 0038/00, Instructions For Use Manual

Page: 79 / 192

Both sieves can be used to process pressed flesh in a second pass if the flesh still contains
too much juice. Prior to that, release the locking screw J13 , remove the press cover J4 ,
clean the outer side of the sieve with a suitable tool (e.g. plastic spatula). Useyourfingers
tocheckwhetherthesievemeshisnotcloggedwithseeds/pips. Should it be the case,
remove the press, clean it thoroughly, re-assemble the press and proceed with processing
the ingredients.
Assembly
Assemble the press on the motor unit head according to Fig. 14 and Fig. 7. First install the
mincer body J0 and then insert the spiral feeder J1 . Push the feeder down until it clicks,
which means it is secured in place. Attach the sieve
J2
or
J14
and nut
J3
the spiral feeder,
and tighten the nut. Unscrew the cover fixing screw J13 so that it will not protrude, to allow
the cover to be put on the sieve. Fix the cover on the sieve. After proper assembly, slightly
tighten the cover screw J4 . Apply reverse procedure to disassemble the unit and remove
it from the motor unit head.
Use
Cut the fruits into pieces to fit the feeding tube opening. Place a stainless bowl or another
suitable container to catch the pressed pulp. Place the juice container J10 without the lid
J11 or another suitable juice container under the outlet. Insert the power cord plug into
a power socket. Put the appliance into operation by turning the speed dial at
8
. Put the
food in the hopper one by one to prevent overfilling the juicer chute to the top. The pusher
is intended for continuous pushing the food to the auger’s reach. Use the pusher after each
piece of food is inserted in the feed chute, not for pushing just after the chute is completely
full to the top edge. If you look inside the feed chute opening after removing the pusher,
you can visually check the auger condition and clearness. If there is too much juice in the
juicer feed chute, switch of the processor, disassemble the juicer, and clean the auger and
the sieve. The pressed juice will flow out from the outlet in the provided container, and the
waste (pulp) comes out from the cover outlet opening J4 . After finishing processing, turn
off the appliance press by turning the dial to position 0/OFF .
We recommend processing at 8 speed.
III. 10 ) Citrus press (O)
Description (Fig. 15)
O0 – Citrus press body O4 – Small press cone
O1 – Driving shaft O5 – Large press cone (adapter – only with O4)
O2 – Container with a sealable outlet O6 – Lid / cover
O3 – Sieve
N – Gearbox – IMPOR TANT: (Citrus press may only be put into operation with gearbox)
Safetyhintsandtips
– The citrus press is designed to process citrus fruits.
– Do not use excessive force when pressing the cone!
Assembly
Assemble the citrus press and attach it to the motor unit head according to Fig. 15
and Fig. 7. Apply reverse procedure to remove it from the motor unit head.
Preparingthefood
Rinse the fruits thoroughly and cut them into halves. Use the small press cone
O4
for small
citrus fruits. Use the large press cone O5 for large citrus fruits.
GB
79 / 184