Section 11 — WaveSample and Layer Parameters
ASR-10 Musician’s Manual
24
Edit/Layer Parameters
Command/Layer Page
These commands allow you to create, copy, and delete whole layers.
CMD
CREATE NEW LAYER
LAYER
Press Command / Layer / 0
Use this command to create a new layer in the currently selected instrument.
• Select CREATE NEW LAYER.
• Press Enter•Yes. The display reads LAYER ## CREATED.
CMD
COPY LAYER
LAYER
Press Command / Layer / 1
Use this command to copy an existing layer and all the WaveSamples in it, either within an
instrument or from one instrument to another.
• Select COPY LAYER. The display reads TO INST=UNNAMED INST.
• Select the destination instrument. Press Enter•Yes.
• Select COPY=PARAMS ONLY/DATA. It is a good idea to choose PARAMS ONLY
when copying a layer within the same instrument, allowing the wave data to be shared. This
will conserve memory. However, always choose DATA when copying a layer from
one instrument to another, or else the destination instrument will not contain the wave data
when it is saved to disk, and subsequently reloaded.
• Press Enter•Yes. The display reads LAYER ## CREATED.
Note:
When STEREO LAYER LINK= ON, this command will also copy the companion layer. However,
in order for this to work properly, there must be two undefined adjacent layers available.
CMD
DELETE LAYER
LAYER
Press Command / Layer / 2
Use this command to delete a layer in the currently selected instrument. This will delete all
WaveSamples in the selected layer as well.
• Choose the layer you want to delete.
• Select DELETE LAYER.
• Press Enter•Yes. The display reads DELETE LAYER ##.
• Press Enter•Yes or Cancel•No.
Note:
If you get the message NO EDIT LAYER SELECTED, simply press Edit and select the layer you
want to copy or delete, and then proceed with the command.
