Section 6 — Effect Parameters
Edit/Effect Parameters
13
ROM-26 EQ + DELAY LFO
EQ + DELAY LFO features a stereo digital delay that provides LFO modulation of a wide range
of delays. This algorithm sounds great with an electric piano, but try it with any source!
EQ+DELAY LFO Signal Routing
BUS1 Left
BUS3 Left
BUS2 Left
BUS1 Right
BUS3 Right
BUS2 Right
EQ
R
Right
Delay
EQ
L
Main
Outputs
Left
Delay
Cross
Regen
Input Level Trim
LFO
Right
Delay
Input
(On/Off)
Regen
Regen
Damping
(LPF)
Damping
(LPF)
Output Level
The BUS1, BUS2, and BUS3 MIX parameters can be routed into the effect with different Dry/Wet
mixes.
The parameters available for this algorithm are:
DLY TIME L
Range:
0 to 845 ms
This parameter determines the amount of time between the input signal and the left delay
output.
DLY TIME R
Range:
0 to 845 ms
This parameter determines the amount of time between the input signal and the right delay
output. Set this differently from the left delay time to achieve dotted 1/8th note type effects.
LFO RATE
Range:
0 to 99
This parameter controls the rate of pitch modulation which is the LFO. To achieve a chorusing
effect, this rate must be very slow.
LFO WIDTH
Range:
0 to 99
This parameter controls the excursion of pitch modulation. Since the rate is usually very slow,
then the width is usually large.
L/R LFO
Range:
OUT-OF-PHASE or IN-PHASE
When this parameter is IN-PHASE, the left and right choruses will modulate their detunes
together. When set to OUT-OF-PHASE, the detune on the left channel will go up while the
detune on the right will go down.
DELAY REGEN
Range:
-99 to +99
This parameter controls the amount of regen (regeneration) applied to the delay time taps. The
sign of the value determines the polarity of the regen.
