Section 11 — WaveSample and Layer Parameters
ASR-10 Musician’s Manual
22
Edit/Layer Parameters
EDIT
LYR VEL LO - HI
LAYER
Press Edit / Layer / 3
This parameter allows you to set the velocity range in which the layer will respond. Outside the
range selected, the layer will not play.
Range: 0 to 127
EDIT
PITCH TBL
LAYER
Press Edit / Layer / 4
This parameter determines whether a layer will use the STANDARD (equal tempered) pitch
table, or play each WaveSample in the layer at the pitch it would play on C4 (NO PITCH), or use
any pitch table you create. See the discussion of the Command/Pitch EDIT PITCH TABLE
command earlier in this section for more on creating and editing pitch tables.
Range: STANDARD, NO PITCH, USER PITCH TABLES 1-8.
EDIT
LYR NAME
LAYER
Press Edit / Layer / 5
Use the data entry controls to change the name of an existing layer, or name a new one that
you’ve just created (the Left/Right Arrow buttons move the cursor, and the Data Entry Slider
and the Up/Down Arrow buttons change the characters).
EDIT
DELAY - VEL AMOUNT
LAYER
Press Edit / Layer / 6 (for Delay) 7 (for Velocity Amount)
The DELAY parameter determines how long voices within the selected layer will wait after a key
is struck before playing. This parameter is adjustable from 0 to 5000, with each value increasing
the delay by 1 millisecond.
The VELOCITY AMOUNT is a modulation amount, with velocity serving as a dedicated
modulation source. Positive values will cause harder velocities to increase the DELAY time.
Negative values will cause harder velocities to decrease the DELAY time. Setting the DELAY to
zero will disable velocity modulation of DELAY time.
EDIT
LAYER RESTRIKE TIME
LAYER
Press Edit / Layer / 8
This parameter sets the amount of decay voices within the selected layer will have after they have
been restruck. The higher the value, the longer the decay time.
Range: 0 to 99
