Section 11 — WaveSample and Layer Parameters
Edit/Filters Parameters
7
• MODE F1=3/LP F2=1/HP. F1 is a 3-pole low-pass filter. F2 is a 1-pole high-pass filter.
F
F
Filter 1 = 3/LP
Filter 2 = 1/HP
Bandpass
+
=
• MODE F1=2/LP F2=2/HP. F1 is a 2-pole low-pass filter. F2 is a 2-pole high-pass filter.
+
=
F
F
Bandpass
Filter 1 = 2 pole / Low-pass
Filter 2 = 2 pole / High-pass
EDIT
CUTOFF F1 (Filter 1) - F2 (Filter 2)
FILTERS
Press Edit / Filters / 1
These parameters allow you to set the initial filter cutoff frequency for each of the two filters.
With a low-pass filter, a setting of 150 lets all the original signal pass through the filter. With a
high-pass filter, a setting of 0 lets through all of the original signal. This setting represents the
“filter floor,” or manual level. The effect of any selected modulators will be added to (or
subtracted from) this level.
Ranges: 0 to 150
EDIT
ENV2 AMT F1 (Filter 1) - F2 (Filter 2)
FILTERS
Press Edit / Filters / 2
Use these parameters to set the depth or amount by which Env 2 will modulate the filter cutoff
frequency. Modulation amounts can be positive or negative.
Ranges: -99 to +99
EDIT
KBD AMOUNT F1 (Filter 1) - F2 (Filter 2)
FILTERS
Press Edit / Filters / 3
These parameters set the amount by which the location of a note on the keyboard will modulate
the filter cutoff frequency (filter keyboard tracking). This allows the relative brightness of a
sound to remain constant over the keyboard. To have a filter track the keyboard exactly you
should set KBD AMT to +50.
Ranges: -99 to +99
