Section 6 — Effect Parameters
Edit/Effects Parameters
5
PHASE DEPTH
Range:
0 to 99
This parameter controls the depth of the notches created by the phasing.
ROM-08 REV
The REV algorithm is similar to the Reverb algorithm with a single LFO.
Assign a voice to BUS1 to get the flanger plus reverb, and use BUS2 for reverb only. BUS3 is dry.
BUS1 REVERB MIX
Range:
0 to 99
This parameter controls the Dry/Wet mix of the Flanger into the Reverb.
BUS2 REVERB MIX
Range:
0 to 99
This parameter controls the Dry/Wet mix of the Reverb for signals sent to BUS2.
REVERB DECAY TIME
HI FREQ BANDWIDTH
LOW FREQ DECAY
REVERB DETUNE RATE
DIFFUSION
REVERB DETUNE AMT
HI FREQ DAMPING
See the descriptions under HALL REVERB.
EARLY RFLECTION LEV
See the description under Reverb.
FLANGE CENTER
Range:
0 to 99
This parameter controls the center of the flanger width.
FLANGE RATE
Range:
0 to 99
This parameter controls the rate of modulation of the flanger effect.
FLANGE WIDTH
Range:
0 to 99
This parameter controls the range of the high to low frequency sweep in the flanger effect.
FLANGE FEEDBACK
Range:
-99 to +99
This parameter controls the amount of feedback applied to the flanger. The sign of the value
determines the polarity of the feedback.
FLANGE DEPTH
Range:
0 to 99
This parameter controls the depth of the notches created by the flanging effect.
ROM-09 ROT. SPKR+REV
A rotating speaker simulation with reverb and distortion. Assign a voice to BUS1 to get both
rotary speaker with distortion and reverb, and use BUS2 for reverb only. BUS3 is a dry bus (no
effect). There are selections on the Variations screen for the Rotary Speaker without Distortion.
BUS1 REV AFTER ROTO
Range:
0 to 99
This parameter controls the Dry/Wet reverb mix of the Rotary Speaker.
BUS2 REVERB MIX
Range:
0 to 99
This parameter controls the Dry/Wet mix of the Reverb from signals sent to BUS2.
