Section 10 — Wave Data Parameters
Command/LFO Page
23
CMD
SCALE DATA
LFO
Press Command / LFO / 6
This command is a “sound sculpting” tool that will enable you to shape the volume contour of
the waveform. As in the other commands, you select some range of data using the start and end
addresses. You also set the scaling range with SCALE START and SCALE END points. These
are multipliers. SCALE START is a multiplier used at the beginning of the source range. SCALE
END is the multiplier used at the end of the source range. If the two scale points are the same,
it’s like multiplying the whole range of data by the same number. So, if you wanted to drop the
level in half, you would set SCALE START and END to 0.5. SCALE DEPTH works as described
previously. If the scale points are different, the data will be scaled using a scaling curve whose
depth is controlled by the SCALE DEPTH.
• Select SCALE DATA. Press Enter•Yes.
• Select START ADDR=## (##). Scroll to END ADDR=## (##). Scroll to SCALE START=##.
• Scroll to SCALE END=##. Scroll to SCALE DEPTH=## DB. Press Enter•Yes.
• The display reads KEEP=OLD NEW. Press Enter•Yes to complete the command (or
Cancel•No to abort the procedure).
Note:
When STEREO LAYER LINK= ON, this command will be simultaneously performed on the
corresponding WaveSample in the companion layer.
