Section 10 — Wave Data Parameters
ASR-10 Musician’s Manual
18
Command/Amp Page
CMD
SPLICE WAVESAMPLES
AMP
Press Command / Amp / 4
This command takes the end of a source sample, and splices it to the beginning or start of the
destination sample. SPLICE WAVESAMPLES is just like a tape splice—a butt splice. You can
also think of it as MERGE with a zero length FADE ZONE.
Before:
After:
1st WaveSample
2nd WaveSample
2nd WaveSample
• Select SPLICE WAVESAMPLES. Press Enter•Yes.
• The display will ask ARE SAMPLES LAYERED? Press Enter•Yes.
• Select FR INST=## L=## WS=##. Scroll to TO INST=## L=## WS=##.
• Scroll to CONVERT SOURCE PITCH. Scroll to CONVERT DEST. PITCH.
• Scroll to VOLUME BALANCE= (-99 to +99). Use the Data Entry Slider to set the balance
between the two.
• Press Enter•Yes. The display reads KEEP=OLD/NEW. Press Enter•Yes to keep the spliced
WaveSamples, or Cancel•No to keep the originals intact.
CMD
FADE IN
AMP
Press Command / Amp / 5
This command scales the volume of the wave data from 0% to 100% to create a digital FADE IN
of the sound. First, select a data range, using the start and end addresses, then choose an
appropriate fade curve. 3 dB fades are very smooth and analogous to the way our hearing
responds to sound.
Before:
After:
START
ADDR
END
ADDR
START
ADDR
END
ADDR
• Select FADE IN. Press Enter•Yes.
• Select START ADDR=## (##). Scroll to END ADDR=## (##).
• Scroll to SCALE DEPTH=## DB. Press Enter•Yes.
• The display reads KEEP=OLD NEW.
• Press Enter•Yes to complete the command (or Cancel•No to keep the original).
Note:
When STEREO LAYER LINK= ON, this command will be simultaneously performed on the
corresponding WaveSample in the companion layer.
